1/3 HP 2600GPH Swimming Pool Cover Pump Automatic On/Off with 25FT Power Cord and 3/4" Standard Hose Fitting, Sump Pump for Pool Draining, Hot-Tub, Rooftop and Patio Drainage, UL Listed
AUTO ON/OFF SWITCH– This automatic pool cover pump features a built-in on/off switch with three water level sensors. It turns on when water rises above 4/5" and shuts off below 2/5", protecting the motor from dry running. When lifted from the water, the pool cover pump stops. Once placed back, it restarts after a 3-second delay to release trapped air.
POWERFUL WATER REMOVAL– With a 1/3 HP motor, this pool water pump can remove up to 2,600 GPH of standing water, great for both pool cover pump inground and pool cover pumps above ground. The bottom suction design removes water down to 2/5", making it a perfect pump for pool cover, boat covers, and window wells. Remove the strainer base to use it as a sump pump for ponds, basements, or other everyday drainage.
RELIABLE & QUIET PERFORMANCE – This pump runs smoothly using magnetic drive technology—no oil seals or bearings needed. The epoxy-sealed motor is leak-proof and built for continuous operation. With an IPX8 waterproof rating, it's safe for full submersion and dependable around your Pool pump covers or backyard setup.
THERMAL OVERLOAD PROTECTION – The motor shuts off automatically when it reaches 221°F and safely restarts once cooled to 167°F. This helps extend pump life and keeps it running safely—especially for long use in pool pumps above ground.
FILTERS OUT DEBRIS TO PREVENT CLOGGING – The strainer base with a rolling ball helps block leaves and large debris. It keeps the pool cover pump automatic on off stable and upright while protecting soft surfaces and hot tubs from damage.
LIGHTWEIGHT AND PORTABLE– Weighing just 8 lbs, this swimming pool cover pump is easy to carry. A 25 ft power cord offers great reach, while the 90° elbow connector makes drainage simple—even in tight spaces like crawl areas or basements. NOTE: Always lift the pump by its handle—never by the power cord. If placing the pump far from your location, tie a rope to the handle for safe and easy placement.
FITS STANDARD HOSES – NO TOOLS NEEDED – This pool cover water removal pump works with standard 3/4" and 1" garden hoses. It includes 3 adapters, 2 clamps, and 2 seals for a quick setup. Just connect and plug in—perfect for rooftops, waterbeds, or seasonal pool cleanup. Great for homeowners and pros alike.
MAINTENANCE TIPS FOR LONG-LASTING PERFORMANCE Regular maintenance is crucial to optimal performance and longevity. When the pump stops working, the most common cause is debris blocking the rotor. In most cases, disassembling and cleaning the rotor can restore normal operation. Routine cleaning prevents rotor blockage, ensures efficient water removal, and extends the overall lifespan of your pump.
10-Piece Drain Cleaning Kit, Drain Cable Cutter Kit for 5/8"" (16mm) Port Heavy-Duty Cables; Compatible with K-400, C-4, C-6, C-7, C-8, and C-9 Models.
KWD 19.500
UFLEX UP28FM / UFlex UP28FM Front Mount Helm Pump
KWD 216
30008571A Flow Sensor Fits for Navien Tankless Water Heater NPE 240A(NG) Series
KWD 6
-8%
110V 1HP 5220GPH Cast Iron Sewage/Effluent Pump with Ajustable Automatic Float Switch, Sump Pump Submersible for Basement Septic Residential-Sewage, 2" NPT Discharge, ETL Listed
KWD 49
