Product introduction
This module is mainly placed behind the stepper motor to obtain the rotation angle of the stepper motor. This principle is to use the AS5600 magnetic code, and then stick a magnet to the spindle of the stepper motor. The magnetic code can obtain information such as the rotation speed of the spindle

Product parameters
Product Name: AS5600 Magnetic Encoder
Product size: 23mm * 23mm
Product type: non-contact magnetic induction
Output mode: IIC, PWM, voltage, etc
PS: Manual measurement, please understand if there is any error!

Product features
1. Made of KB-A grade FR-4 glass fiber board, the thickness is 1.6mm, and the board surface is flat and not easy to bend. Each PCB board has been tested by flying needles, and the quality is worth relying on
2. Non-contact magnetic induction angle measurement module. High accuracy, multiple output modes, IIC, PWM, voltage, etc
3. The AS5600 is also equipped with an intelligent low-power mode that automatically reduces power consumption.The input pin I (DIR) selects the direction of rotation of the output polarity

Instructions for use
VCC--3.3V
GND - Power Ground
Out--PWM/Analog Voltage Output
DIR - rotation direction (ground = clockwise value increases; connect VCC = clockwise value decreases)
SCL-IIC communication clock line
SDA--IIC communication data cable
GPO - mode selection (internal pull-up, ground = programming mode B)