3PCS For Servo Tester 3-Gears Servo Test with Indicator Anti-reverse Connection
The servo tester is controlled by a microcontroller and has three control modes that Switching by keypad. These are manual mode, return to centre mode and automatic mode.
The blue status light changes when the function is switched. Anti-reverse connection function.
No need to worry about burning the circuit board if you reverse the connection. High stability and accuracy.
1. Manual mode: Rotate the potentiometer and the servo will rotate with it. High level time from 0.5ms to 2.5ms 2. Return to centre mode: automatically return to the centre of the servo, the high level time is 1.5ms 3. Auto mode: Automatic test of the minimum and maximum servo angle. High level time from 0.5ms to 2.5ms.
4. With anti-reverse connection circuit, no need to worry about reverse connection and burn the board. 5. Two servos can be connected at the same time for testing. 6. Power supply input voltage is 5V Instructions for use As shown in the diagram, connect the power cable and servo signal cable according to the pin definition, press the button to switch the working mode, the potentiometer is effective in manual mode.
1PCS Milliohm Meter Low Resistance Tester Ohmmeter to Measure Resistance Value
KWD 15.500
Virtual Oscilloscope Logic Analyzer I2C SPI CAN Uart Full-Featured Signal Generator 16MHz
KWD 13.500
XR2206 Function Signal Generator DIY Kit Sine, Triangle, Square Output 1HZ-1MHZ New
KWD 3.500
Electronic Load Tester 5A 35W Battery Capacity Resistor Tester Voltmeter Ammeter Adjustable Constant Current Electronic Load
KWD 8
