Specification:
Chip: L298 dual H-bridge driver chip
Drive voltage: 6.5V-27V
Rated output current per port: 7A
Storage Temperature: -25℃-80℃
Operating mode: H-bridge driver (dual)
Maximum power: 160W
The control signal voltage: 3-6.5V, which are the enable signal and the forward and reverse control signal respectively.
Driver Board Size：55*55*16mm
Driver Board Weight:20g
Mounting hole diameter: 3mm. When installing, pay attention to the short circuit on the back.

Package Included:
3 * L298 Motor Driver controller Board Module

Suitable motor parameters:
Motors with a rated voltage of 24V are suitable for motors with a rated power of 115W or less or rated current of 7A or less to work at full capacity for a long time

Motors with a rated voltage of 12V are suitable for motors with a rated power of 40W or less or rated current of 7A or less to work at full capacity for a long time

Note:
1. The driver power supply cannot be connected in reverse. It is recommended to connect a fuse in series at the power interface. The voltage should be between 6.5 and 27V.

2. The motor interface cannot be short-circuited, otherwise the driver module may burn out. It is recommended to connect a 10A fuse in series at the motor interface.

3. When switching between forward and reverse directions, you must brake for more than 0.1S before reversing. Do not reverse before the motor stops, otherwise the driver may be damaged.