Specification:
Model: DN25 3 Wire 2 Control
Material: Brass, 304 Stainless Steel, Special Rubber
Driver Operating Voltage: DC24V
Power Consumption: 7.5VA
Valve Body Pressure: 1.6Mpa
Allowable Pressure: 0.13Mpa
Applicable Medium Temperature: 2-95
Applicable Environment Temperature: 0-60

Package List:
1 * Motorized Ball Valve

Installation and Commissioning:
1. Please read the instructions before using, and installed by professionals.
2. direction must be the same as the direction of the arrow on the valve body.
3. The valve body must be located the fan water tray, to ensure that the drip drop into the water tray.
4. Valve body and driver must be installed in the vertical direction ±60° range, should have at least 30mm space .
5. Two and more than two of the electric valve can not be parallel, if the need for parallel relays to be separated.
6. The valve body is installed and the pipeline through the test pressure before installing the drive.
7. If the driver has been installed on the body, then during the installation and commissioning it must not force on the drive, otherwise it will damage the drive.
8. Drive can not be wrapped with insulation material
9. Drives must be reliable grounded by conductors not less than 1.5mm, other lines shall conform to the relevant standards of electrician.
10. After installation and check it correct, do not water-energized commissioning. Please observe the three full operating cycles of the drive to determine for a minute if the parts are normal and correct.
11. After the water- commissioning, then start the water commissioning.