Specifications:
Material: cement resistance
Model: 20W
Light source power: 21 W
Voltage: 12-24V
Applicable models: Motorcycle electric car
Light source: LED
Color temperature: 500
Service life time: 4200h

Package List:
4 * Motorcycle LED Decoder

Installation Notes:
The left and right lines of the turn signal are not the same. If you change the LED lights left and right, you must install one product for each side. If you change the lights before and after, you can only install two. However, the front left and rear left turn signals (with one resistor) and the front right and rear right turn signals (with one resistor) must be wired to resistance. For ease of installation, it is recommended to install one resistor for each turn signal.

Note:
1. Because the resistor has heat, do not directly attach the resistor to or install on the material of the glue or cloth, and install it directly on the iron plate.
2. The resistance and the wire should be separated by more than 1 cm (cm). When the resistor and the wire are in direct contact, the heat of the resistor will cause the heat of the surface of the casing to melt the wire sheath.