How to Use?

Part One: Device Startup

Push the switch on the right side of the device upward. The red light will illuminate, and the green and yellow lights will flash simultaneously, indicating successful startup. If not, you can try restarting it.

After the device is started, do not read any cards at this point. Press the device's card-writing button to write a card as an all-zero ID card. After successful writing, the buzzer will sound twice, and the green light will be on.

Press any key, and the yellow light will turn on, indicating that the device is working.

Part Two: Reading and Writing Cards

Push the switch on the right side of the device upward. The device will emit "beep-beep" sounds 2 to 3 times, and the green and yellow lights will flash simultaneously, indicating successful startup.

First, place the card on the antenna position on the left side of the device. Press the read card button, and the device will emit a beep sound to indicate that the card has been read and written. The green light will also illuminate.

Replace the card with a new one. Press the write card button, and the device will emit "beep-beep" sounds twice to indicate successful writing. The green light will illuminate, indicating successful writing.

Place a writable EM4305 key on the back of the copier, then press "Write."

Note: Please remember that not every copier can be compatible with all RFID cards available.