This is a worthy upgrade to the stock pickups in the squier tele. This Tele Pickups low output vintage wind 5.9k have that classic 50s 60s whatever tele twang and honk clear tone. It willl almost remind you of the Fender Vintage reissue 52's clarity and balance with the ability to growl when pushed. Tonality and bite is superb, with that single-coil bite, but none of the usual pick-up buzz/noise.

Features:
- Triple wax dipped and vacuum sealed to eliminate any unwanted feedback and noise.
- It use shielded wire instead of the flimsy two-part wire, safe wiring with good noise protection.
- Fits perfectly well in a ‘92 American Standard cavity.
- Position: Bridge, Neck
- Resistance: 5.5K-6K
- Weight: 150g/5.29 ounces

How to install ?
At the first, you only need to make sure that pick guard is tight on these, and require some modification though you could open the pups hole up just a little bit, if you don't want to butcher your pick guard, you can use a fine file and just gently take off a few thousands off each side of the hole. To enlarge the installation holes in the neck bridge to accommodate the original screws and springs. Each pickup has two wires(Shielded Wire) that need to be soldered. Get your soldering iron to the 'right' temperature to just melt the solder, not so hot it just keeps melting it.

Package Included:
1 x Neck Pickup
1 x Bridge Pickup
5 x Screws
5 x Springs