This module uses MCP4725 I2C DAC IC with on-board power boost and rail-to-rail signal amplifier, which takes 0-5V output of the DAC and covert the same to 0-10V DAC signal. This 0-10V output is programable with 12-bit resolution which will be having 4096 levels of voltage as output and with an accuracy of ±1%. In addition it is possible to share two DACs of this type share the same bus and the I2C address can be changed by plugging or removing the I2C address jumper. If any design is needed more than two of these DAC modules, it is advised to use a I2C multiplexer controller and it will allow you to connect multiple of these DAC modules with one I2C master device. - Speed ; up to 3.4Mbps - Rail to Rail Operational Amplifier Three modes of operation are supported. - standard 100kbps - fast 400kbps - high speed 3.4Mbps It is possible to interface this DAC module with following platforms . - Raspberry Pi - Arduino - Onion Omega - Beaglebone - Windows, - Particle Photon