Insta-Cure (TM) is the thinnest viscosity CA glue offered by BSI. It has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while applying the CA around the edges of the seam. At the moment CAs cure, they give off a vapor that can irritate the nose and eyes, so be prepared. Thin CAs work very well on soft, porous woods since they penetrate into the wood and form more than just a surface bond. INSTA-SET (TM) is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization. INSTA-SET (TM) in a spray bottle is normally used to cure the CA that flows from joints when parts are pressed together. Applying an additional bead of thick CA along a seam and then curing it with INSTA-SET (TM) significantly enhances a joint's strength. For difficult to bond materials, INSTA-SET TM) can be applied to one surface and CA to the opposite surface. When brought together, they will bond instantly. INSTA-SET (TM) is formulated with a strawberry scent and activates CA in 6 to 8 seconds without any degrading of the CAs strength, which can occur with many other accelerators. It is compatible with all surfaces, even clear plastic and white foam.