Model Number: 37GB-520
Voltage: 12V DC
No Load Current: 0.15A
Working Current: 0.6A
No Load Speed: 5 - 600RPM
Torque: 0.19 - 23.4 kgf.cm
Power: 5W
Shaft Diameter: 6mm(D-Shaft)
Shaft Total Length: 86mm
Commutation: Brush
Installation Screw Size: M3
Rotation Direction: CW/CCW
Stall Current: 1.65A
Product Name: 37GB520 Geared Motor
Reduction Ratio: 1 : 17.4
Output Shaft Length: 15mm
D-Shaped Output Shaft Size: 6 x 14mm (0.24inch x 0.55inch) (D x L)
Gearbox Size: 37 x 23mm (1.46inch x 0.91inch) (D x L)
Motor Size: 36.2 x 33.3mm (1.43inch x 1.31inch) (D x L)
Storage Temperature: 0 - 40 Celsius degree
Storage Humidity: 15 - 90 percent RH
Motor Use Temperature: 0 - 70 Celsius degree
Note:
1. If the motor does not work properly, it may be because the electrode piece may be knocked into the motor during transportation due to collision, causing connection problems. Gently pull out a little and try again.
2. When you use the motor, there should be no binding objects, such as adhesive should not flow into the bearing through the rotating shaft, which will harm of the motor.
3. When soldering the motor terminals of positive and negative power supply, the temperature of the soldering iron should be 340 Celsius degree to 40 Celsius degree and the heating time should be within 3 seconds.
4. When installing the motor, the screws are too long, which may cause contact between the motor itself and the rotor, and may affect the characteristics.
5. Handling motors: Please gently, as far as possible the use of motor shell part.
6. Motor wiring: Red lead to the positive electrode, black lead to the negative pole, if reversed, the motor rotation in the opposite direction.