Description:

1. An easy one step connection of wires, soldered, insulated and sealed Can be ideal use in marine and automobile applications Polyolefin tubing in outside and hot melt adhesive in inside Solder and seal and with advanced waterproof function.

2. Polyolefin heat shrink butt connectors improved pullout strength, provides seal, strain relief, cable check, and insulation Operating.

Temperature Range:

Operating temperature : -55℃～125℃

Minimum shrink temperature : 60℃

Starting temperature of solder melt : 138℃

Temperature of fully solder melt : 160℃

Instructions for use:

There is strip wire insulation 1/3 inch (about 0.3 cm) at both ends. Insert the solder sleeve and string the wires together.Continuously rotate the connector while using the heat gun to apply heat evenly around the solder until it flows into the copper wire.Then apply heat to both ends of the tube with a heat gun until the adhesive flows and seals the line.Wait for the heat to dissipate before use.

Note:

It is recommended to use a heat gun with a temperature of 1500-2000 watts and maintain a distance of 35 cm from the solder joints when applying heat.If the heat gets too close, the wire connector will break easily.

Package included:

60 x White Shrink Connectors:Diameter 1.7 mm,Cable cross-section 0.25-0.34mm² (AWG:26-24)

100 x Red Shrink Connectors:Diameter 2.7 mm, Cable cross-section 0.5-1.0mm² (AWG:22-18)

60 x Green Shrink Connectors: Diameter 4.0 mm, Cable cross-section 1.0-1.5mm² (AWG:18-16)

100 x Blue Shrink Connectors: Diameter 4.5mm, Cable cross-section 1.5-2.5mm² (AWG:16-14)

40 x Yellow Shrink Connectors: Diameter 6.0 mm, Cable cross-section 4.0-6.0mm² (AWG:12-10)