Electronic Engine Control
DSE6120 MKIII AMF Auto Stop Generator Controller Panel Control Module
Description:
The DSE6110 is an Auto Start Control Module suitable for a wide variety of single gen-set applications.
Monitoring speed, frequency, voltage, current, oil pressure, coolant temperature and fuel level, the modules will display warnings, shutdown and engine status information on the back-lit screen and illuminated LED.
Features
Back-lit text display
Front panel editing
LED and alarm indication
Power Save mode
CAN and Magnetic Pick-up/Alt. versions available (specify on ordering)
PC and front panel configuration
6 Digital inputs
3 Analogue inputs
6 Outputs (4 configurable on Magnetic Pick-up/Alt., 6 configurable on CAN version)
Configurable timers and alarms
Alternative configuration
Event Log (10)
Remote Start input
3 Phase generator monitoring
Current Monitoring and protection
Battery voltage monitoring
Engine pre-heat
Hours counter
Comprehensive shutdown or warning on fault condition
Specification
Operating Voltage DC8.0V to DC35.0V,Continuous Power Supply.
Alternator Input Range 15V - 360 V AC (ph-N)
3-Phase4-Wire 26V - 620 V AC (ph-ph)
3-Phase3-Wire 15V - 360 V AC (ph-N)
Single-phase2-wire 15V - 360 V AC (ph-N)
2-Phase3-Wire:
Alternator Frequency 50/60Hz
Speed Sensor voltage VPP 2.2 - 100Vpp (Peak to peak)
Speed Sensor Frequency 10000Hz (max)
Start Relay Output 16Amp Controller Power Voltage Output
Fuel Relay Output 16Amp Controller Power Voltage Output
Programmable Relay Output 1 7Amp 250VAC Voltage Free Output
Programmable Relay Output 2 7Amp 250VAC Voltage Free Output
Programmable Relay Output 3 16Amp 250VAC Voltage Free Output
Programmable Relay Output 4 16Amp 250VAC Voltage Free Output
Case Dimension 210mm x 152 mm x 48 mm
Panel Cutout 186mm x 141mm
C.T. Secondary 5A Rated
Working Conditions Temperature: (-25~+70)°C Humidity:(20~90)%
Storage Condition Temperature::(-40~+85)°C
Protection Level IP55:When waterproof rubber seal installed between the controller and panel fascia.
IP42:When waterproof rubber seal is not installed between the controller and panel fascia.
Insulating Intensity Object: input/output/power
Quote standard: IEC688-1992
Test way: AC1.5kV/1min leakage current:3mA