Battery Storage for 1" Version: The 1" version includes a storage tube that fits two CR123/A (not included) or 1 18650 (not included). The cap applies light pressure to the batteries to hold them in place. If there is any rattling, tighten the rear cap. No lithium batteries are sold with the product.
Height Options: Available in different heights: .250" or .500" or .750" or 1"
Secure Fit: Wings on the side snap over the sides of the stock, and the circular nub on the inside of the riser seats into the hole on the top of the stock. If needed, you can tap the riser into place with a rubber mallet to get the circular nub and hole on stock to line up. This dual interface system ensures a tight fit without forward-to-rear movement. To remove, push up firmly on the overhang wing portion on one side - it will take some muscle.
Sight Compatibility: The taller versions of these risers will make the iron sights unusable. They are intended for use with an optic with a 1/3 co-witness or higher optic.
Made in USA: 2200+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.
Description
Cheek Riser for B5 Bravo available in different heights and colors. It will need to be extended a few positions (varies depending on setup) to run properly. Usually 4 positions.
Hammy3DPrints Open Center Killflash Hex Anti-Reflection Device for 30mm LPVO Scopes
KWD 7
Killflash Hex Anti-Reflection Device Compatible with Vortex Crossfire Red Dot
KWD 6.500
Killflash Hex Anti-Reflection Device Compatible with Holosun 510C
KWD 8.500
Hammy3DPrints Killflash Hex Anti-Reflection Device Compatible with Holosun ARO Red Dot
KWD 8.500
