Extracts stuck cases from standard sizer dies without damaging the die using a very simple two step removal process. Includes tap, drill bit, allen screw, allen wrench and remover. Will work with any brand of die. Instructionsfor use: unscrew the expander-decapping rod until the decapping pin is free of the primer flash hole in the stuck case. Secure The reloading die in a vice and drill The case head with the included drill bit. Drill straight through the primer pocket and the primer flash hole. Next tap the case head The included 1/4 inch -20 Tap. Place the stuck case remover body onto the case head and turn the cap screw with the allen-type wrench until the case is pulled from the die. Discard the case and reassemble the die.