Q&A from users

- Q: How to install the ball stopper?
- A: This is mostly for use with a new cable. The cable has to be went through the hole of the ball. Since most cables have loops at their ends, to install this on a cable that's already in service, you'd have to cut the loop off. But then the cable wouldn't be serviceable. You can get the cable and end-fittings from Home Depot, so replacing most cables is pretty easy.
- A: In my case, I had to remove the existing cable from the machine by unbolting the cable from where it was attached to the frame. I then threaded the new rubber stopper onto the cable and then ran the cable through the pulley system and back to where I had removed the cable from the frame of the machine.