use: 1. +5 +5 is the positive input port of the power supply, which can be connected to a voltage of 3.3V~5V
2. GND GND is the negative input port of the power supply. OUT OUT is the signal output port, which is connected to the I/O port of the single-chip microcomputer. Generally, it is connected to an external interrupt.
For other main control boards or higher-level main control boards (such as Arm), if you need to set the I/O port to input/output mode, you must set it to input mode/receive mode, otherwise it cannot be used. 51 series MCU can be used directly, no need to set input and output mode
Note: For Arduino players should set the MCU's I/O port to input mode/receive mode, otherwise it cannot be used.
Teyleten Robot AS5600 Magnetic Encoder 12bit high Precision Magnetic Induction Angle Measurement Sensor Module 3.3V (5PCS)
KWD 4.500
Teyleten Robot GY-31 TCS3200 TCS230 Color Sensor Module Color Recognition Sensor Module for Arduino
KWD 4.500
Teyleten Robot CP2112 Debug Board USB to SMBus I2C Communication Module 2.0 MicroUSB 2112 Evaluation Kit for CCS811 Sensor Module for arduino 1pcs
KWD 3
Teyleten Robot KY-040 Rotary Encoder Brick Sensor Module Switch Development 360 Degrees with Knobs Cap for Arduino AVR PIC 5pcs
KWD 4
