Dirty Dingo Motorsports Slider SBC/BBC to LS Engine Conversion Swap Mounts Plain Steel
Dingo Sliders give up to 2 inches of adjustment, and positions the LS engine ¼” higher than other adapter plates. You can use your factory rubber engine mount, any aftermarket urethane or solid engine mounts. These mounts will also work if you have a clam shell/motor mount bracket (often referred to as elephant ears or buckets) combo for 72+ GM vehicles. Simply bolt your clam shell to the outer plate and install. Precision CNC laser cut from .250 cold roll plate steel. Dingo Sliders will allow you to mount the engine in the original bell housing position, or move the engine forward up to 2 inches. May require using aftermarket oil pan. * These mounts are sold in pairs. "D" is marked for Driver's side, "P" is marked for Passenger side. * Will not fit Dart aftermarket blocks. * These mounts will not clear low mount a/c or low mount GTO rear alternator brace, but they will clear Camaro low mount alternators with limited movement. * Will not fit on 1967-72 4X4 Chevrolet GMC trucks. These trucks require a complete front cross member. * Mounts are plain raw steel. Black texture powder coat is available.