This tool includes 1 large rod and a 3/4 inch and 1 inch remover
Fits most 2000 and later Harley-Davidson motorcycle wheels
The Pit Posse wheel bearing remover set is primarily designed for use with radial ball bearings on MOST Harley-Davidson and American V-Twin motorcycles
Driving wheel bearings out can be a hair pulling task, especially without damaging an expensive wheel
This set makes this job almost effortless
Safe and easy
Remove bearings in seconds
Each remover has a tapered end so part of the remover will slip inside the bearing
To use this tool you simply put the proper size remover in the bearing, then flip wheel & bearing over so the remover is against the floor, then take the rod tool insert into remover and tap firmly into place (the remover has a slot in it for the rod tool to slide into)
Once you have the rod firmly in place simply lift the wheel and bearing off the ground and tap again and the bearing will fall out
When the remover is against the ground and tapped on, the remover is spread apa
PLEASE NOTE - While this kit includes 3/4 and 1 inch collets, it is important to note that some 2007 Softail models, excluding Springer models, use a 25mm radial ball bearing on the front wheel. This suggests that a separate 25mm collet would be needed for those specific applications, or a different kit may be required. If you are dealing with a 25mm bearing, confirm whether your specific motorcycle model is compatible with the included collets or if a separate 25mm collet or a different remover set is necessary.