Free Tool Kit Requirement
Limited 1 Set of Tool Kit for each Account ONLY regardless of quantity purchase Included
(6) 6" by 4" Vinyl Sheets. (Not a precut letter) (Emblem not included)
These are not precut because a vinyl sheet is easier to apply than a precut decal. A precut decal requires perfect alignment, while a sheet allows you trim off the excess vinyl. (Allowing more room for error)
This kit will not work with some model years because the emblems will not allow the vinyl to adhere properly
Installation Instructions
Recommended installation weather is to be above 50 degrees and not to be in direct sun light
If you end up with small bubbles under the decal, they will dissipate in the heat after a couple days
Important
Use the following step if you are having issues getting the decal to stay stuck down in the corners of the emblem. It will also help if the decal is bunching up around the curves
Lightly heat the decal with a hair dryer and carefully use the squeegee to force the decal into the corners of the emblem. For the curves, it helps to slide the wedge tool around the beveled edge with light pressure
Material has no warranty for fading. Fluorescent Neon colors tend to fade faster than normal colors. Fading can be reduced with over lamination, preventing stretched areas, which fade even faster, and shelter from high U.V. times during the day
Due to different monitors/calibrations, colors may vary slightly from the pictures
Film colors can vary slightly from roll to roll. For the most consistency, please purchase a full roll