DENDF-505 Features: -Provides the technician with the power they need to shrink, pull rocker panels, hail damage, creases, dents in hard to access areas and all types of metal damage. -The 'Original Maxi' Dent Pulling Station. -Provides the technician with the power they need to shrink, pull rocker panels, hail damage, creases, dents in hard to access areas and all types of metal damageFrom light to heavy pulls, The Maxi has the power and the accessories to do it all. Pull by hand with pull rod or attach the slide hammer rod for heavier action. Pull creases evenly with the "Wiggle Wire" and Bear Claw" system. The leverage bar assists in power pulling, but also allows delicate pulls along moulding lines. Weld stud pins to create a strong pulling tab or use the shrinking tip to correct over-stretched metal. 21 feet of power and 9 feet of weld cable make sure the technician can reach anywhere on the vehicle. Complete kit includes: The Maxi 220 volt unit, two light pulling rods, two slide hammer rods with strike weight, stud pin electrode, shrinking electrode, wiggle wire weld tip, a nine and four finger Bear Claw, 500 stud weld pins, 1 pound of wiggle wire, 21 feet of power cable, and nine feet of welding cable.. Product Type: -Parts & Accessories. Generic Specifications: -Very powerful - 220 volt power. Dimensions: Overall Height - Top to Bottom: -15 Inches. Overall Width - Side to Side: -10 Inches. Overall Depth - Front to Back: -21 Inches. Overall Product Weight: -10 Pounds. Warning: This product can expose you to chemicals which is [are] known to the State of California to cause cancer and birth defects or other reproductive harm.