Flywheel Puller Removal Tool with Puller Hole Replacement for Predator 212 224cc 196cc GX160 GX200 Engine Coleman Mini Bike CT200U CT200U-EX BT200X Axis M200 Baja Warrior MB200 Go Kart Parts
Fitment: Flywheel remove tool is for most flywheels with steel adjustable timing hubs, PVL clone flywheel and raceseng flywheel with puller hole
Applicable Engine: Predator 6.5hp 212cc OHV horizontal shaft gas engine (not for hemi engine), GX160 GX200 6.5hp clone engine, for Harbor Freight
Compatibility: Coleman CT200U CT200U-EX BT200X, KT196 CK196-T mini bike go kart, Axis M200, Massimo MB200, Trailmaster MB200, Baja Warrior MB165 MB200
Good Flywheel Remove Tool: Compared with hitting the crankshaft with a hammer, using this tool to remove the flywheel is more convenient, labor-saving and avoiding damage to the crankshaft and flywheel
Installation Notices: 1. Install the threaded screws into clean and lubricated puller holes, be sure to thread screws in fully. 2. Tighten the nuts evenly back and forth in 1/2 turn increments until the flywheel pulls off. 3. Stubborn flywheels may require that you hit the center of the puller block with a hammer once significant pressure is applied by tightening the nuts. Be careful not to strike the threaded rods and never hit the flywheel itself with a hammer
Note: Pls check installation pictures if have problems on installation
-39%
95400 in-Line Dowel Pin Puller Master Set,Dowel Dismantling Tools Easily Remove Dowel Pin,Puller Sets Saving Time and Effort
KWD 40
-20%
8-Inch Electrical Disconnect Pliers 4-Pack – Professional Automotive Connector Removal Tool Kit for Fuel Lines, Sensors & Weatherpack Connectors
KWD 8
Bad Parking Cards 100 Pieces You Suck At Parking Card 4.72"X5.31" Funny Parking Violation Cards with Multi Violation Reasons
KWD 2
7.5 x 17 FT Garage Floor Mat,2.5 mm Thickness Diamond PVC Garage Flooring Roll, Anti-Slip Shop Floor & Parking mats for Workshop,Gym,Golf Cart Parking or Trailers
KWD 57.500
