Over-discharge protection: When is about to run out and the voltage is as low as 3.0V, the protection board will also be turned off and can no longer be discharged, forming an over-discharge protection effect.
Overcharge protection: When charging, when the voltage reaches the highest voltage (4.2V), the protection board will automatically power off and shut down, indicating that it will not continue to charge when fully charged, form an overcharge protection.
Short circuit protection: When an accidental short circuit occurs, the protection board will automatically shut down within a few milliseconds and will not be powered on again. Note that the cell is short-circuited (not through the protection board). The protection board will also fail due to continuous high current, or the components are heated and damaged.
Please note: overcurrent protection is not a panacea, please do not continue to charge and discharge with large current, or the current and voltage beyond the range, otherwise the protection board will be damaged and invalid
WARNING: Connector's RED wire is positive electrode“+”. BLACK wire is negative electrode“-”. Device's positive electrode"+" shall connect to connector's positive electrode"+"; Device's negative electrode "-" shall connect to connector's negative electrode "-". WRONG CONNECTION MAY CAUSE PRODUCT FAILURE. Confirm polarity of the connector and your device before connection!

Specification:
Standard voltage: 3.7V
Capacity: 3000mAh
Approximate weight: 50g
Dimensions (±2mm): 67*36*10mm/ 2.64*1.41*0.39inchinch(L*W*H)
Discharge rate: 1C
Working current: 1.5A
Maximum discharge current: 3C
Overcurrent protection: 1.8-2.1A
Connector Type: Micro JST 1.25
Standard Charging Method:
Charge to 4.25V with a constant current of 0.2C, and then charge it with a constant voltage of 4.2V until the charging current is less than or equal to 0.05C.
Package Included:
4PCS 3000mAh