2.0 Link Shield -Connect a 2.0 Muscle Sensor Compatible with Arduino R3 microcontroller -Use 3.5mm TRS Jack to Link Boards via 3.5mm TRS-to-TRS Cable -Snap connectors -Easy Stacking
KWD 6
2.0 Wireless Shield - wirelessly Transmit Data with The ESP32-WROOM chip - Input 5V via USB C Connector - Output 3.3V - ESD Protection Diodes for USB Data Lines
KWD 11
2.0 LED Shield - Visualize Muscle Activation with Light - Power The Myoware 2.0 Muscle Sensor - Equipped with snap connectors Easily Stack on top Side of Muscle Sensor
KWD 11
2.0 compatible with Arduino Shield- Connect to your compatible with Arduino R3 board & your MyoWare 2.0 Muscle sensor- Connect up to 6 sensors and/or link shields using TRS to TRS audio cables
KWD 4.500
2.0 Muscle Sensor-Compatible with Arduino- All-in-one electromyography (EMG) sensor from Advancer Technologies -Measure muscle activity by detecting its electric potential-Keyed Snap Connector
KWD 16.500
2.0 Cable Shield - Non-Wearable Project Connector - On-Board snap connectors - 3.5mm TRS Jack Attach a Traditional Three-Electrode Sensor Cable - Board Dimensions: 1.48in x 1.41in
KWD 3.500
MyoWare Electrodes (50-Pack)
KWD 14.500
MyoWare 2.0 Reference Cable - 10 pack - Reach separate sections of the body or nonadjacent muscles near the targeted muscles - Attach a sensor pad to the electrode snap - Plug the pin into its housing
KWD 7
MyoWare 2.0 Reference Cable- 3-inch Long Cable-Connect to The MyoWare 2.0 Muscle Sensor Extend The Reference pin-Add a Sensor pad Measure Raw Filtered & Rectified Electrical Activity of Target Muscle
KWD 3